C-15
Cisco SCE8000 GBE Installation and Configuration Guide
Appendix C Cisco Service Control Engine System Log Messages
Informational Messages, Severity Level 6
Error Message %LOCAL7-6-PEER_IP_CHANGED:"IP address of peer box was changed (was
old-ip-addr, changed to new-ip-addr)."
Explanation
This message is displayed while the existing IP address of the peer box is being
changed. The message appears when the existing IP address and the new IP addresses are not
matched in the peer Cisco SCE box.
In this message, old-ip-addr indicates either the old IP address or the existing IP address of the peer
box, and new-ip-addr indicates the new IP address.
Recommended Action None.
Error Message %LOCAL7-6-PEER_IP_SET:"Peer box IP address is ip-addr."
Explanation
This message is displayed when Cisco SCE sets the IP address of the peer box for the
first time. It verifies if the previous IP address is set; if not, the IP address is set to a new IP address.
–
In this message, ip-addr is the new IP address set for the peer box.
Recommended Action None.
Error Message %LOCAL7-6-SET_DEFGW:"IP Default gateway set to def-gw-ip-addr.
Explanation
This message is displayed while a new default gateway for a particular slot is being set.
Recommended Action None.
Error Message %LOCAL7-6-FINISHED_VERIFY: "Package verification finished"
Explanation
This debug-related information message is displayed when the verification of a package
is completed successfully.
Recommended Action None.
Error Message %LOCAL7-6-STARTED_EXTRACT:"Package extraction started on file
'pkg-filename'"
Explanation
This debug-related information message is displayed when package extraction begins.
Extraction can occur with or without the verification of a package. This message returns the name
of the file on which extraction is initiated.
–
In this message, pkg-filename indicates the name of the package file.
Recommended Action None.
Error Message %LOCAL7-6-FINISHED_EXTRACT: "Package extraction finished"
Explanation
This debug informational message is displayed when the package extraction process is
completed (with or without verification). The filename is displayed after the extraction is completed.
Recommended Action None.
To Next Page
Loading...
Need help?
General
