C-14
Cisco SCE8000 GBE Installation and Configuration Guide
Appendix C Cisco Service Control Engine System Log Messages
Informational Messages, Severity Level 6
Error Message %LOCAL7-6-EXTERNAL_BYPASS_WIRE_TEST_AUTO_NEG_TEMP_OFF:"External
bypass test is on. deactivating auto-negotiation for interface <intf-name>."
Explanation
This message is displayed while performing the external bypass test. Auto negotiation,
if supported, is deactivated for the interface.
In this message, intf-name is the name of the interface.
Recommended Action None.
Error Message %LOCAL7-6-EXTERNAL_BYPASS_WIRE_TEST_AUTO_NEG_BACK_ON:"Ending external
bypass test. Restoring the activation status of auto-negotiation for interface
<intf-name>"
Explanation
This message is displayed after the external bypass test is completed, and
autonegotiation is reactivated for the corresponding interface.
In this message, intf-name is the name of the interface.
Recommended Action None.
Error Message %LOCAL7-6-EXTERNAL_BYPASS_WIRE_TEST_EB_ON:"External bypass test is
on. Manually activating the external bypass units."
Explanation
This message is displayed to indicate that the external bypass test is on, and that the
external bypass units are being manually activated.
Recommended Action None.
Error Message %LOCAL7-6-EXTERNAL_BYPASS_WIRE_TEST_EB_BACK:"Ending external bypass
test. Restored the external bypass units’ activation status"
Explanation
This message is displayed after the completion of the external bypass test, and during
the restoration of the external bypass units’ activation status.
Recommended Action None.
Error Message %LOCAL7-6-SET_IP:"IP address of slot slot-num set to ip-addr, subnet
mask subnet-mask."
Explanation
This message is displayed while the IP address and subnet mask for the corresponding
slot is being set.
In this message, ip-addr indicates the IP address of the slot, subnet-mask indicates the subnet mask
of the slot, and slot-num indicates the number of the slot.
Recommended Action None.
To Next Page
Loading...
Need help?
General
