C-22
Cisco SCE8000 GBE Installation and Configuration Guide
Appendix C Cisco Service Control Engine System Log Messages
Informational Messages, Severity Level 6
Error Message %LOCAL7-6-REPLACE_ENDED: "Application replace ended on slot %ld,
replace finished."
Explanation
This message is displayed when application replacement is completed.
Recommended Action None.
Error Message %LOCAL7-6-TRAVERSING_ALL: "slot number %d analyzing transport layer
information"
Recommended Action
This message is displayed when a request is made by a user from external
management through the CLI to parse the transport layer instead of performing payload operation
of a packet for analysis. The user can specify whether or not to scan only the payload or the entire
transport layer of the packet for analysis.
Recommended Action None.
Error Message %LOCAL7-6-TRAVERSING_ONLY_PAYLOAD: "slot number %d analyzing payload
only"
Explanation
This message defines the details of the traverse layer in a particular slot with the slot
number that is allowed to traverse only the payload.
Recommended Action None.
Error Message %LOCAL7-6-DAEMON_ENABLED: "Telnet daemon was enabled."
Explanation
This message is displayed when the telnet process daemon is enabled.
Recommended Action None.
Error Message %LOCAL7-6-DAEMON_DISABLED: "Telnet daemon was disabled."
Explanation
This message is displayed when the telnet process daemon is disabled.
Recommended Action None.
Error Message %LOCAL7-6-DEBUG_TELNET_ACCESS: "<%s> access to debug-telnet (port
2300)"
Explanation
This message is displayed when debug telnet access to port 2300 is enabled.
Recommended Action None.
Error Message %LOCAL7-6-DEBUG_SHELL_ACCESS: "<%s> access to debug-shell (port 2301)"
Explanation
This message is displayed when debug shell access to port 2301 is enabled.
Recommended Action None.
To Next Page
Loading...
Need help?
General
