EasyManua.ls Logo

Cisco SCE 8000

Cisco SCE 8000
248 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
C-38
Cisco SCE8000 GBE Installation and Configuration Guide
Appendix C Cisco Service Control Engine System Log Messages
Informational Messages, Severity Level 6
Error Message %LOCAL7-6-SM_TAKEOVER: "Redundancy: SM connection status is up while
down in peer box."
Explanation
This message is displayed to indicate that the Subscriber Manager connection is down
due to the session timeout. The connection status is verified in the cascade connection when one of
the Cisco SCE platforms has the Subscriber Manager connection and tries to verify another Cisco
SCE platform connection.
Recommended Action None.
Error Message %LOCAL7-6-SYSTEM_CHANGE_TO_STANDBY: "Redundancy: User request -
changed system to standby."
Explanation
In the cascade state machine, this message is displayed to indicate that the system state
has changed from the active state to the standby state.
Recommended Action None.
Error Message %LOCAL7-6-FOUND_NO_IMPROPER_CONNECTIONS :
"RedundancyManager:Previously found improper cascade connections are now
fixed/disconnected."
Explanation
This message is displayed to indicate that no improper connections are indicated from
the Remote Procedure Call (RPC) layer.
Recommended Action None.
Error Message %LOCAL7-6-NOTIFY_USER_EVENT_ON: "Started filtering packets of type
'%s' received on interface # %d (<%s>). module # %d. Reason
Explanation
This message indicates that the attack filter event has occured and starts filtering the
given types of packets on the corresponding interface.
Recommended Action None.
Error Message %LOCAL7-6-NOTIFY_USER_EVENT_OFF: "Stopped filtering packets of type
'<%s>' received on interface # %d (<%s>). module # %d. Reason
Explanation
This message indicates that an attack filter event has occurred, and stops filtering the
given type of packets on the corresponding interface.
Recommended Action None.
Error Message %LOCAL7-6-UNFORCE_LINK_DOWN: "Link on port %d is unforced down."
Explanation
This message is displayed when the link on a specific port is in the unforced down state.
Recommended Action None.

Table of Contents

Other manuals for Cisco SCE 8000

Related product manuals