Cisco SCE 8000

C-43
Cisco SCE8000 GBE Installation and Configuration Guide
Appendix C Cisco Service Control Engine System Log Messages
Warning Messages, Severity Level 4
Warning Message %LOCAL7-4-DBG_INIT_FAILED_OPEN_FILES: "DBG Init failure
Explanation
This message is generated while opening new files for logging failure cases.
Recommended Action None.
Warning Message %LOCAL7-4-DBG_INIT_FAILED_OPEN_HIST_FILES: "DBG Init failure
Explanation
This message is generated when failure occurs while opening a new histogram file or an
existing histogram file.
Recommended Action None.
Warning Message %LOCAL7-4-DBG_INIT_FAILED_LOAD_HIST_FILES: "DBG Init failure:
Failed loading histogram file (bad file or format)."
Explanation
This message is generated when Cisco SCE fails to load the watermarks from the
histogram file due to the following reasons:
– Failed to read and find the histogram file.
– Watermark found, but failed to be removed from the message hash.
– Watermark not found in the histogram file.
Recommended Action None.
Warning Message %LOCAL7-4-DBG_INIT_HEADERS_CORRUPTED1: "DBG Init problem
Explanation
This message is generated when the header obtained from the first debug log file is
corrupted even if the file is not in the full, empty, or active state.
Recommended Action None.
Warning Message %LOCAL7-4-DBG_INIT_FAILED_AFTER_HC1: "DBG Init failure
Explanation
This message is generated when there is an unsuccessful attempt to open or create a new
debug file, and this operation is attempted when there is an error in the header obtained from the
first debug log file because it is corrupted, that is, the file is not in the full, empty, or active state.
Recommended Action None.
Warning Message %LOCAL7-4-DBG_INIT_HEADERS_CORRUPTED2: "DBG Init problem
Explanation
This message is generated when the header obtained from the second debug log file is
corrupted, that is, the file is not in the full, empty, or active state.
Recommended Action None.