C-44
Cisco SCE8000 GBE Installation and Configuration Guide
Appendix C Cisco Service Control Engine System Log Messages
Warning Messages, Severity Level 4
Warning Message %LOCAL7-4-DBG_INIT_FAILED_AFTER_HC2: "DBG Init failure
Explanation
This warning message is generated when the open or create operation of a new debug
file fails. This operation is attempted when there is an error in the header obtained from the second
debug log file because it is corrupted, that is, the file is not in the full, empty, or active state.
Recommended Action None.
Warning Message %LOCAL7-4-DBG_INIT_BOTH_FULL: "DBG Init problem
Explanation
This message is generated when the status of the headers obtained from both the debug
log files are in the full state. Close the existing files and create or open a new file.
Recommended Action None.
Warning Message %LOCAL7-4-DBG_INIT_FAILED_AFTER_BF: "DBG Init failure
Explanation
This message is generated when the create or open operation of a new file fails when
the existing file is closed, with the status of the headers obtained from both the debug log files in the
full state.
Recommended Action None.
Warning Message %LOCAL7-4-DBG_INIT_BOTH_ACTIVE: "DBG Init problem
Explanation
This message is generated when the status in the headers obtained from both the debug
log files are in the active state. Close the existing second file and create a new first file or open an
existing first file.
Recommended Action None.
Warning Message %LOCAL7-4-DBG_INIT_FAILED_AFTER_BA: "DBG Init failure
Explanation
This message is generated when the task of creating or opening a new file fails after the
existing log file is closed and when the status of the headers obtained from both the debug log files
are in the full or active state.
Recommended Action None.
Warning Message %LOCAL7-4-DBG_DEVICE_CREATION_FAILED: "DBG Init failure
Explanation
This message is generated when the creation of a logger device fails.
Recommended Action None.
To Next Page
Loading...
Need help?
General
