3-6
Cisco UCS Invicta Scaling System Administration and Configuration Guide, Version 5.0.1.1a
Chapter 3 SSR Configuration
Step 4 Choose Delete Bond to delete or Cancel to return to the Network Settings window.
Enable/Disable Bond
An existing Network Interface Configuration (NIC) Bond can be enabled or disabled, depending on its
initial state, using the right-click menu:
Step 1 .Choose SSR Configuration > Network Settings.
The Network Settings window appears.
Step 2 Highlight a Bond from the Ethernet Bond Status list by mousing over it and right click.
The right-click menu appears.
Step 3 Choose Enable /Disable Bond.
The confirmation dialog box appears, for example, a Disable Bond confirmation.
Step 4 Choose Enable/Disable Bond or Cancel to return to the Network Settings window.
Enable/Disable Fibre Channel Interface
To enable/disable an FC Interface, do the following:
Step 1 Choose SSR Configuration > Network Settings.
The Network Settings window appears.
Step 2 Highlight a Port from the FC Interface Status list by mousing over it and right click.
The right-click menu appears.
Step 3 Choose Enable/Disable.
The confirmation dialog box appears, for example, the Set Offline confirmation.
Note A READY status in the FC Interface Status GUI window indicates that the FC port in online but that
there is an issue between the port and the FC Switch. Troubleshooting is needed to verify cable
connectivity or other cause.
Step 4 Choose Online/Offline or choose Cancel to return to the Network Settings window.
Create a Virtual Interface
A virtual interface can be created from an existing Network Interface Configuration (NIC) Bond from
the right-click menu:
Step 1 Choose SSR Configuration > Network Settings.
The Network Settings window appears.
To Next Page
Loading...
