3-13
Cisco UCS Invicta Scaling System Administration and Configuration Guide, Version 5.0.1.1a
Chapter 3 SSR Configuration
System Update
Clicking System Update opens a dialog box that asks the Administrator to choose the system update file
that was sent by Cisco, which may have been saved locally.
Uploading this file loads the system update onto the Cisco UCS Invicta Scaling System. After the file
has been authenticated by the system, the Administrator is prompted through the remaining update
process.
Table 3-5 Support Settings Button Functionality
Button Description
Test Autosupport The Test Autosupport button is a trigger that
generates an Autosupport message that is outside
of the regular schedule and that tests the
Autosupport relay setting. This test includes all of
standardly collected data.
Post Service The Post Service button is used for triggering
communication to the Autosupport server once
the service repair or maintenance action was
performed on the system by technician.
System Update The System Update button is used when a
permissioned Administrator receives a file
containing an update.
Uninstall Update Uninstall update button is visible immediately
after the update was installed and is used for
rolling back previously installed update.
This button is only visible if a user is
permissioned to uninstall an update.
Shutdown Shutdown the Cisco UCS Invicta Scaling System.
A dialog box appears to verify the Shutdown
command to avoid any unintentional action.
Reboot Reboot the Cisco UCS Invicta Scaling System. A
dialog box appears to verify the Reboot command
to avoid any unintentional action.
Caution A device reboot is required
to complete an upgrade.
Ensure that all hosts are
disconnected from the
device so that no IO is
running during the upgrade
installation.
To Next Page
Loading...
