Cisco VG204 - Connecting the Cables; About Connecting the Cables; Connecting the LAN and Console Cables

1-7
Cisco VG202 and Cisco VG204 Voice Gateways Software Configuration Guide
OL-16191-01
Chapter 1 Understanding Interface Numbering and Cisco IOS Software Basics
Where to Go Next
Where to Go Next
Now that you have learned some Cisco IOS software basics and seen a typical deployment scenario, you
can begin to configure the VG by using the command-line interface (CLI).
Remember that:
• You can use the question mark (?) and arrow keys to help you enter commands.
• Each command mode restricts you to a set of commands. If you have difficulty entering a command,
check the prompt and then enter the question mark (?) for a list of available commands. You might
be in the wrong command mode or be using the wrong syntax.
• To disable a feature, generally enter the keyword no before the command; for example, no ip
routing.
• You need to save your configuration changes to NVRAM so that the changes are not lost if there is
a system reload or power outage.
Go to Chapter 2, “Using the setup Command Facility,” to begin configuring the VG.