EasyManuals Logo

Cisco VG204 Software Configuration Guide

Cisco VG204
50 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #19 background imageLoading...
Page #19 background image
2-5
Cisco VG202 and Cisco VG204 Voice Gateways Software Configuration Guide
OL-16191-01
Chapter 2 Using the setup Command Facility
Completing the Configuration
!
interface FastEthernet0/0
media-type 100BaseX
half-duplex
ip address 9.13.38.150 255.255.255.0
!
interface FastEthernet0/1
shutdown
no ip address
dialer-list 1 protocol ip permit
!
end
Completing the Configuration
When you have all the information that the setup command facility has prompted you for, the
configuration appears.
To complete your configuration, follow these steps:
Step 1 A setup command facility prompt asks if you want to save this configuration, with the following options:
[0] Go to the IOS command prompt without saving this config.
[1] Return back to the setup without saving this config.
[2] Save this configuration to nvram and exit.
If you answer 0, the configuration information you entered is not saved, and you return to the Cisco VG
enable prompt (
VG#). Enter setup to return to the System Configuration Dialog.
If you answer 1, you return to setup without saving the configuration.
If you answer 2, the configuration is saved and you are returned to the user EXEC prompt (VG>).
Step 2 When the messages stop appearing on your screen, press Return to get the VG> prompt.
Step 3 The VG> prompt indicates that you are now at the command-line interface (CLI) and you have just
completed a basic Cisco VG configuration. However, this is not a complete configuration. At this point
you have two choices:
Run the setup command facility again and create another configuration. Enter the following:
VG> enable
Password:
password
VG# setup
Modify the existing configuration or configure additional features with the CLI as described in
Chapter 3, “Configuring with the Command-Line Interface.

Table of Contents

Other manuals for Cisco VG204

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco VG204 and is the answer not in the manual?

Cisco VG204 Specifications

General IconGeneral
Number of FXS Ports4
Voice CodecsG.711, G.729, G.729a, G.729ab
Operating Temperature32 to 104°F (0 to 40°C)
Humidity10% to 90% non-condensing
Network Interface1 x 10/100 Ethernet
Protocol SupportSCCP, SIP
Power SupplyAC 100-240V, 50-60Hz
Weight2.2 lbs (1 kg)
Storage Temperature-20 to 70°C

Related product manuals