Cisco VG204 Software Configuration Guide

3-4
Cisco VG202 and Cisco VG204 Voice Gateways Software Configuration Guide
OL-16191-01
Chapter 3 Configuring with the Command-Line Interface
Configuring Fast Ethernet Interfaces
• Power on the Cisco VG by plugging in the external power supply.
Perform the following steps to configure Fast Ethernet interfaces.
SUMMARY STEPS
1. enable
2. configure terminal
3. ip routing
4. interface type number
5. ip address ip address subnet mask
6. exit
7. Ctrl-z
DETAILED STEPS
Command or Action Purpose
Step 1
enable
Example:
VG# enable
Enters privileged EXEC mode.
Step 2
configure terminal
Example:
VG# configure terminal
Enters global configuration mode.
Step 3
ip routing
Example:
VG(config)# ip routing
Enables routing protocols as required for your global
configuration. This example uses IP routing.
Step 4
interface type [number]
Example:
VG(config)# interface fastethernet 0/0
Enters interface configuration mode. You have entered
interface configuration mode when the prompt changes
to
VG(config-if)#.
Step 5
ip address ip address subnet mask
Example:
VG(config-if)# ip address 172.16.74.3
255.255.255.0
Assigns an IP address and subnet mask to the interface.

Cisco VG204 Specifications

General

Number of FXS Ports	4
Voice Codecs	G.711, G.729, G.729a, G.729ab
Operating Temperature	32 to 104°F (0 to 40°C)
Humidity	10% to 90% non-condensing
Network Interface	1 x 10/100 Ethernet
Protocol Support	SCCP, SIP
Power Supply	AC 100-240V, 50-60Hz
Weight	2.2 lbs (1 kg)
Storage Temperature	-20 to 70°C