4-6
Cisco VG202 and Cisco VG204 Voice Gateways Software Configuration Guide
OL-16191-01
Chapter 4 Configuring Voice
Auto-Configuration on the Cisco VG202 and Cisco VG204 Voice Gateways
7. fax protocol t38 [nse[force]]
8. ccm-manager sccp local interface-type interface-number
9. ccm-manager config server tftp_ip_address
10. ccm-manager sccp
11. exit
DETAILED STEPS
Command or Action Purpose
Step 1
enable
Example:
VG# enable
Enters privileged EXEC mode.
Step 2
configure terminal
Example:
VG# configure terminal
Enters global configuration mode. You have entered
global configuration mode when the prompt changes to
VG(config)#.
Step 3
interface
type slot/port
Example:
VG(config)# interface fastethernet 0/0
Enters interface configuration mode and specifies the
type of interface you plan to configure. You have entered
interface configuration mode when the prompt changes
to
VG(config-if)#.
Step 4
ip address dhcp
Example:
VG(config-if)# ip address dhcp
Acquires an IP address on an interface from the Dynamic
Host Configuration Protocol (DHCP).
Step 5
sccp local
interface-type interface-number
port
port-type
Example:
VG(config)# sccp local fastethernet 0/0
Enables the SCCP and its related applications
(transcoding and conferencing).
Step 6
voice service voip
Example:
VG(config)# voice service voip
Enters voice-service configuration mode and specifies a
voice-encapsulation type.
Step 7
fax protocol t38 [nse[force]]
Example:
VG(config)# fax protocol t38 nse force
Specifies the global default ITU-T T.38 standard fax
protocol to be used for all VoIP dial peers.
Step 8
ccm-manager sccp local
interface-type
interface-number
Example:
VG(config)# ccm-manager sccp local fastethernet
0/0
Selects the local interface that the SCCP application uses
to register with Cisco CallManager.
To Next Page
Loading...
Need help?
General
