Contents
xi
Catalyst 3750 Switch Software Configuration Guide
78-16180-02
Access Ports 11-3
Trunk Ports 11-3
Routed Ports 11-3
10-Gigabit Ethernet Interfaces 11-4
Switch Virtual Interfaces 11-4
EtherChannel Port Groups 11-5
Connecting Interfaces 11-5
Using Interface Configuration Mode 11-7
Procedures for Configuring Interfaces 11-8
Configuring a Range of Interfaces 11-9
Configuring and Using Interface Range Macros 11-10
Configuring Ethernet Interfaces 11-12
Default Ethernet Interface Configuration 11-12
Configuration Guidelines for 10-Gigabit Ethernet Interfaces 11-14
Configuring Interface Speed and Duplex Mode 11-14
Configuration Guidelines 11-15
Setting the Interface Speed and Duplex Parameters 11-15
Configuring IEEE 802.3z Flow Control 11-17
Configuring Auto-MDIX on an Interface 11-18
Configuring Power over Ethernet on an Interface 11-19
Adding a Description for an Interface 11-20
Configuring Layer 3 Interfaces 11-21
Configuring the System MTU 11-22
Monitoring and Maintaining the Interfaces 11-24
Monitoring Interface Status 11-24
Clearing and Resetting Interfaces and Counters 11-25
Shutting Down and Restarting the Interface 11-25
CHAPTER
12 Configuring Smartports Macros 12-1
Understanding Smartports Macros 12-1
Configuring Smartports Macros 12-2
Default Smartports Macro Configuration 12-2
Smartports Macro Configuration Guidelines 12-3
Creating Smartports Macros 12-4
Applying Smartports Macros 12-5
Applying Cisco-Default Smartports Macros 12-6
Displaying Smartports Macros 12-8
To Next Page
Loading...
Need help?
General