Contents
xxvi
Catalyst 3750 Switch Software Configuration Guide
78-16180-02
Configuring the Physical Interfaces 33-16
Configuring EtherChannel Load Balancing 33-18
Configuring the PAgP Learn Method and Priority 33-19
Configuring LACP Hot-Standby Ports 33-20
Configuring the LACP System Priority 33-21
Configuring the LACP Port Priority 33-22
Displaying EtherChannel, PAgP, and LACP Status 33-23
CHAPTER
34 Configuring IP Unicast Routing 34-1
Understanding IP Routing 34-2
Types of Routing 34-2
IP Routing and Switch Stacks 34-3
Steps for Configuring Routing 34-4
Configuring IP Addressing 34-5
Default Addressing Configuration 34-5
Assigning IP Addresses to Network Interfaces 34-6
Use of Subnet Zero 34-7
Classless Routing 34-7
Configuring Address Resolution Methods 34-9
Define a Static ARP Cache 34-10
Set ARP Encapsulation 34-11
Enable Proxy ARP 34-11
Routing Assistance When IP Routing is Disabled 34-12
Proxy ARP 34-12
Default Gateway 34-12
ICMP Router Discovery Protocol (IRDP) 34-13
Configuring Broadcast Packet Handling 34-14
Enabling Directed Broadcast-to-Physical Broadcast Translation 34-14
Forwarding UDP Broadcast Packets and Protocols 34-15
Establishing an IP Broadcast Address 34-16
Flooding IP Broadcasts 34-17
Monitoring and Maintaining IP Addressing 34-18
Enabling IP Unicast Routing 34-19
Configuring RIP 34-20
Default RIP Configuration 34-20
Configuring Basic RIP Parameters 34-21
Configuring RIP Authentication 34-23
Configuring Summary Addresses and Split Horizon 34-23
Configuring Split Horizon 34-24
To Next Page
Loading...
Need help?
General