Contents
xxvii
Catalyst 3750 Switch Software Configuration Guide
78-16180-02
Configuring OSPF 34-25
Default OSPF Configuration 34-26
Configuring Basic OSPF Parameters 34-27
Configuring OSPF Interfaces 34-28
Configuring OSPF Area Parameters 34-29
Configuring Other OSPF Parameters 34-30
Changing LSA Group Pacing 34-32
Configuring a Loopback Interface 34-32
Monitoring OSPF 34-33
Configuring EIGRP 34-34
Default EIGRP Configuration 34-35
Configuring Basic EIGRP Parameters 34-36
Configuring EIGRP Interfaces 34-37
Configuring EIGRP Route Authentication 34-38
Monitoring and Maintaining EIGRP 34-39
Configuring BGP 34-40
Default BGP Configuration 34-42
Enabling BGP Routing 34-44
Managing Routing Policy Changes 34-46
Configuring BGP Decision Attributes 34-47
Configuring BGP Filtering with Route Maps 34-49
Configuring BGP Filtering by Neighbor 34-50
Configuring Prefix Lists for BGP Filtering 34-51
Configuring BGP Community Filtering 34-52
Configuring BGP Neighbors and Peer Groups 34-54
Configuring Aggregate Addresses 34-56
Configuring Routing Domain Confederations 34-56
Configuring BGP Route Reflectors 34-57
Configuring Route Dampening 34-58
Monitoring and Maintaining BGP 34-59
Configuring Protocol-Independent Features 34-60
Configuring Distributed Cisco Express Forwarding 34-60
Configuring the Number of Equal-Cost Routing Paths 34-62
Configuring Static Unicast Routes 34-62
Specifying Default Routes and Networks 34-63
Using Route Maps to Redistribute Routing Information 34-64
Configuring Policy-Based Routing 34-68
PBR Configuration Guidelines 34-69
Enabling PBR 34-69
To Next Page
Loading...
