Cisco XR 12000 Series User Manual

interworking ethernet
To configure ethernet interworking across a pseudowire that enables delivery of Ethernet frames, use the
interworking ethernet command in p2p configuration submode. To undo the configuration, use the no form
of this command.
interworking ethernet
no interworking ethernet
Syntax Description
Specifies the type of pseudowire and the type of traffic that can flow across
it.
ethernet
Command Default
None
Command Modes
p2p configuration submode
Command History
ModificationRelease
This command was introduced.Release 4.2.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationTask ID
read, writel2vpn
Examples
This example shows how to configure an ethernet interface:
RP/0/0/CPU0:router# configure
RP/0/0/CPU0:router(config)# l2vpn
RP/0/0/CPU0:router(config-l2vpn)# Xconnect group grp1
RP/0/0/CPU0:router(config-l2vpn-xc)# p2p AC1_to_PW1
RP/0/0/CPU0:router(config-l2vpn-xc-p2p)# interworking ethernet
RP/0/0/CPU0:router(config-l2vpn-xc-p2p)#
Cisco IOS XR Virtual Private Network Command Reference for the Cisco XR 12000 Series Router, Release 4.3.x
38 OL-28460-01
Virtual Private Network Commands
interworking ethernet

Cisco XR 12000 Series Specifications

General

Brand	Cisco
Model	XR 12000 Series
Category	Network Router
Language	English