Cisco XR 12000 Series User Manual

timeout setup (L2TP)
To configure timeout definitions for L2TP session setup, use the timeout setup command in L2TP class
configuration mode. To return to the default behavior, use the no form of this command.
timeout setup seconds
no timeout setup seconds
Syntax Description
Time, in seconds, to setup a control channel. Range is 60 to 6000 seconds. Default
is 300 seconds.
seconds
Command Default
seconds: 300
Command Modes
L2TP class configuration
Command History
ModificationRelease
This command was introduced.Release 3.7.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
read, writel2vpn
Examples
The following example shows how to configure a timeout value for L2TP session setup of 400 seconds:
RP/0/0/CPU0:router# configure
RP/0/0/CPU0:router(config)# l2tp-class cisco
RP/0/0/CPU0:router(config-l2tp-class)# timeout setup 400
Related Commands
DescriptionCommand
Enables L2TP authentication for a specified L2TP class name.authentication (L2TP), on page 4
Cisco IOS XR Virtual Private Network Command Reference for the Cisco XR 12000 Series Router, Release 4.3.x
146 OL-28460-01
Virtual Private Network Commands
timeout setup (L2TP)

Cisco XR 12000 Series Specifications

General

Series	XR 12000
Product Type	Router
Category	Network Router
Architecture	Distributed
Maximum Slots	16
Number of Slots	16
Routing Protocol	BGP, OSPF, IS-IS, EIGRP, RIP
Operating System	Cisco IOS XR
Form Factor	Chassis
Supported Interfaces	Ethernet
Management	CLI, SNMP
Power Supply	AC
Interfaces/Ports	Multiple, depending on line cards
Ports	Multiple, depending on line cards

Summary

Virtual Private Network Commands

authentication (L2TP) Command

Enables L2TP authentication for a specified L2TP class name.

l2vpn Command

Enters L2VPN configuration mode.

neighbor (L2VPN) Command

Configures a pseudowire for a cross-connect.

pw-class (L2VPN) Command

Enters pseudowire class submode to define a pseudowire class template.

p2p Command

Enters p2p configuration submode to configure point-to-point cross-connects.

timeout setup (L2TP) Command

transport mode (L2VPN) Command

tunnel-template Command

xconnect group Command

Virtual Private LAN Services Commands

action (VPLS) Command

Configures bridge behavior when learned MAC addresses reach the MAC limit.

bridge-domain (VPLS) Command

Establishes a bridge domain and enters L2VPN bridge group configuration mode.

bridge group (VPLS) Command

Creates a bridge group to contain bridge domains and assign interfaces.

limit (VPLS) Command

mac (VPLS) Command

maximum (VPLS) Command

mtu (VPLS) Command

neighbor (VPLS) Command

shutdown (Bridge Domain) Command

time (VPLS) Command

vfi (VPLS) Command