Cisco XR 12000 Series User Manual

vfi (VPLS)
To configure virtual forwarding interface (VFI) parameters and to enter L2VPN bridge group bridge domain
VFI configuration mode, use the vfi command in L2VPN bridge group bridge domain configuration mode.
To remove all configurations that are made under the specified VFI, use the no form of this command.
vfi vfi-name
no vfi vfi-name
Syntax Description
Name of the specified virtual forwarding interface.
vfi-name
Command Default
None
Command Modes
L2VPN bridge group bridge domain configuration
Command History
ModificationRelease
This command was introduced.Release 3.7.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Use the vfi command to enter L2VPN bridge group bridge domain VFI configuration mode.
You cannot configure a pseudowire directly under a bridge domain. Therefore, a psuedowire must be configured
under a VFI, which is configured under a bridge domain.
Task ID
OperationsTask ID
read, writel2vpn
Examples
The following example shows how to create a VFI:
RP/0/0/CPU0:router# configure
RP/0/0/CPU0:router(config)# l2vpn
RP/0/0/CPU0:router(config-l2vpn)# bridge group 1
RP/0/0/CPU0:router(config-l2vpn-bg)# bridge-domain bar
RP/0/0/CPU0:router(config-l2vpn-bg-bd)# vfi v1
RP/0/0/CPU0:router(config-l2vpn-bg-bd-vfi)#
Cisco IOS XR Virtual Private Network Command Reference for the Cisco XR 12000 Series Router, Release 4.3.x
222 OL-28460-01
Virtual Private LAN Services Commands
vfi (VPLS)

Cisco XR 12000 Series Specifications

General

Brand	Cisco
Model	XR 12000 Series
Category	Network Router
Language	English