Cisco XR 12000 Series

pw-ether
To configure a PWHE Ethernet interface, use the pw-ether command in global configuration mode or in p2p
configuration submode. To return to the default behavior, use the no form of this command.
pw-ether value
no pw-ether value
Syntax Description
Value of the PWHE Ethernet interface. The range is from 1 to 32768.
value
Command Default
None
Command Modes
Global configuration
p2p configuration
Command History
ModificationRelease
This command was introduced.Release 4.2.1
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationTask ID
read, writeinterface (global configuration)
read, writel2vpn (p2p configuration)
Examples
This example shows the sample output of a PWHE Ethernet interface configuration in global configuration
mode:
RP/0/0/CPU0:router# configure
RP/0/0/CPU0:router(config)# interface pw-ether 78
RP/0/0/CPU0:router(config-if)# attach generic-interface-list interfacelist1
Cisco IOS XR Virtual Private Network Command Reference for the Cisco XR 12000 Series Router, Release 4.3.x
OL-28460-01 71
Virtual Private Network Commands
pw-ether