Cisco XR 12000 Series

This example shows the sample output of a PWHE Ethernet interface configuration in p2p configuration
submode:
RP/0/0/CPU0:router# configure
RP/0/0/CPU0:router(config)# l2vpn
RP/0/0/CPU0:router(config-l2vpn)# xconnect group xc1
RP/0/0/CPU0:router(config-l2vpn-xc)#p2p grp1
RP/0/0/CPU0:router(config-l2vpn-xc-p2p)#interface pw-ether 78
This example shows the sample output of L2 overhead configuration for the PW-HE interface:
RP/0/0/CPU0:router# configure
RP/0/0/CPU0:router(config)# interface pw-ether 78
RP/0/0/CPU0:router(config-if)# l2overhead 32
This example shows the sample output of Load-interval configuration for the PW-HE interface:
RP/0/0/CPU0:router# configure
RP/0/0/CPU0:router(config)# interface pw-ether 78
RP/0/0/CPU0:router(config-if)# load-interval 60
This example shows the sample output of how to set logging of interface state change for the PW-HE interface:
RP/0/0/CPU0:router# configure
RP/0/0/CPU0:router(config)# interface pw-ether 78
RP/0/0/CPU0:router(config-if)# logging events link-status
This example shows the sample output of MAC address configuration for the PW-HE interface:
RP/0/0/CPU0:router# configure
RP/0/0/CPU0:router(config)# interface pw-ether 78
RP/0/0/CPU0:router(config-if)# mac-address 44-37-E6-89-C3-93
This example shows the sample output of MTU configuration for the PW-HE interface:
RP/0/0/CPU0:router# configure
RP/0/0/CPU0:router(config)# interface pw-ether 78
RP/0/0/CPU0:router(config-if)# mtu 128
This example shows the sample output of bandwidth configuration for the PW-HE interface:
RP/0/0/CPU0:router# configure
RP/0/0/CPU0:router(config)# interface pw-ether 78
RP/0/0/CPU0:router(config-if)# bandwidth 256
Related Commands
DescriptionCommand
Enters p2p configuration submode to configure point-to-point
cross-connects.
p2p, on page 74
Cisco IOS XR Virtual Private Network Command Reference for the Cisco XR 12000 Series Router, Release 4.3.x
72 OL-28460-01
Virtual Private Network Commands
pw-ether