Cisco XR 12000 Series

retransmit (L2TP)
To configure retransmit retry and timeout values, use the retransmit command in L2TP class configuration
mode. To return to the default behavior, use the no form of this command.
retransmit {initial initial-retries| retries retries| timeout {max| min} timeout}
no retransmit {initial initial-retries| retries retries| timeout {max| min} timeout}
Syntax Description
Configures the number of SCCRQ messages resent before giving up on a
particular control channel. Range is 1 to 1000. Default is 2.
initial initial-retries
Configures the maximum number of retransmissions before determining that
peer router does not respond. Range is 5 to 1000. Default is 15.
retries retries
Configures the maximum and minimum retransmission interval in seconds
for control packets. Range is 1 to 8. Maximum timeout default is 8 seconds.
Minimum timeout default is 1 second.
timeout {max | min}
timeout
Command Default
initial retries: 2
retries: 15
min timeout: 1
max timeout: 8
Command Modes
L2TP class configuration
Command History
ModificationRelease
This command was introduced.Release 3.7.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
read, writel2vpn
Cisco IOS XR Virtual Private Network Command Reference for the Cisco XR 12000 Series Router, Release 4.3.x
78 OL-28460-01
Virtual Private Network Commands
retransmit (L2TP)