Cisco XR 12000 Series User Manual

interworking ipv4
To configure IPv4 interworking, use the interworking ipv4 command in the p2p configuration submode. To
return to the default behavior, use the no form of this command.
interworking ipv4
no interworking ipv4
Syntax Description
Sets IPv4 interworking.ipv4
Command Default
None
Command Modes
p2p configuration submode
Command History
ModificationRelease
This command was introduced.Release 4.2.0
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
Task ID
OperationsTask ID
read, writel2vpn
Examples
The following example shows how to configure an attachment circuit on a TenGigE interface:
RP/0/0/CPU0:router# configure
RP/0/0/CPU0:router(config)# l2vpn
RP/0/0/CPU0:router(config-l2vpn)# xconnect group gr1
RP/0/0/CPU0:router(config-l2vpn-xc)# p2p gr1
RP/0/0/CPU0:router(config-l2vpn-xc-p2p)# interworking ipv4
RP/0/0/CPU0:router(config-l2vpn-xc-p2p)#
Related Commands
DescriptionCommand
Enters p2p configuration submode to configure point-to-point
cross-connects.
p2p, on page 74
Cisco IOS XR Virtual Private Network Command Reference for the Cisco XR 12000 Series Router, Release 4.3.x
OL-28460-01 37
Virtual Private Network Commands
interworking ipv4

Cisco XR 12000 Series Specifications

General

Brand	Cisco
Model	XR 12000 Series
Category	Network Router
Language	English