Pag. 8
3. MAINTENANCE
3.1 GENERAL SERVICE INFORMATION:
• Wear gloves and glances when you make the maintenance;
• Do not perform maintenance while engine is running. Injury to your fingers, hands or head
may result ;
• Perform maintenance on firm, level ground, using hard workstand, and not directly on
chassis;
• Always install new gaskets, o-rings, piston pin clips, snap rings ect..when disassembling
• When tightening bolts, nuts or screw, start with the larger diameter or inner fasteners, and
tighten them to the specified torque using a criss-cross pattern;
• Use genuine Ciscomotors parts when maintenance your Snap100
• Clean parts in non-flammable cleaning solvent when disassembling. Lubricate any sliding
surface, O-rings and seals before reassembling.
W
W
A
A
R
R
N
N
I
I
N
N
G
G
Gasoline or low flash point solvents are highly flammable or explosive and must never be
used for cleaning parts . Fire or explosion could result.
• After reassembling, chek all parts for proper installation and operation
NOTE:
• Specification are listed chapter 2.
3.2 ROUTINE CLEANING
• If the SNAP100 were only little dirty to clean up it with clean dusts cloth without
dissolvents
• If the SNAP100 were much dirty to clean up it with biodegradable detergents and not with
dissolvents, lubricate where is nececessary.
Number engine
Number reducer
To Next Page
Loading...
Need help?
General
