Disassembly, Reassembly and Lubrication
CL-S6621 3-24
Notes on reassembling:
• Be sure that the end of wire spring (“A”/”B” in the above figure) of the “Unit, Ribbon Sensor
F”/“Unit, Ribbon Sensor R” is set under the “Cover Ribbon Tension Sensor” as shown below.
• After assembling the “Unit, Ribbon Sensor F”/“Unit, Ribbon Sensor R”, perform “
3-7-2 Ribbon
Slant Elimination Adjustment”.
Unit, Ribbon
Tension Shaft F
Cover Ribbon
Tension Sensor
A
Spring end
[Example of “A”]
To Next Page
Loading...
