Citizen CL-S6621 - SA PF Motor

Disassembly, Reassembly and Lubrication
3-47 CL-S6621
BH, M3x4 (NI)
SA, PF Motor Cable
SA PF Motor
Wire Tie
J7
J6
3-6-19. SA PF Motor
1. Remove the “Unit, Mechanism”. Refer to “3-6-13(1) Unit, Mechanism”.
2. Cut the “Wire Tie”. Then remove 2 screws (BH, M3x4 (NI)) and detach the “SA PF Motor”
Block.
3. Disconnect the “SA, PF Motor Cable” from the “SA PF Motor”.
3-6-20. “Carriage Adjust Sensor L”, “SA, Head Up Switch” and “SA Ref
Sen PCB”
(1) “Carriage Adjust Sensor L” and “SA, Head Up Switch”
1. Remove the “Unit, Mechanism”. Refer to “3-6-13(1) Unit, Mechanism”.
2. Remove the “Unit, Sensor U”. Refer to “
3-6-15 Unit, Sensor U”.
3. Remove the “Unit, Head”. Refer to “
3-6-17 Unit, Head”.
4. Remove the “SA, PF Motor”. ”Refer to “
3-6-19 SA PF Motor”.
5. Turn over the PF Block.
6. Cut the “Wire Tie” (2 pcs.) and unhook the wires from the 2 hooks.
SA, Head Up Switch
Wire Tie
Hook
Carriage Adjust Sensor L
[Bottom View]
"PF" Block
Hook
Wire Tie