Citizen CL-S6621 - Disassembling the Roll Paper Shaft

Disassembly, Reassembly and Lubrication
CL-S6621 3-54
3-6-24. Disassembling the “Roll Paper Shaft”
1. Remove the 2 screws (BHT (#2), M3x6 (NI)) and detach the “Shaft Paper”.
2. Remove the “Slider PNE”, “Lever PNE” and “Spring PNE” from the “Cover Shaft Paper”.
NOTE: To remove the “Lever PNE”, pull it out from the “Slider PNE”.
Notes on reassembling:
• Apply FLOIL G-311S to the convex parts (2 places) of the “Lever PNE. (See the mark
Ì shown in
the figure.)
• Insert the “Lever PNE” into the “Slider PNE” as shown below.
• Insert the end of the “Spring PNE” (“A”) into “A’ ” of the “Slider PNE”. Also, insert the projection
“B” into the slit “B’ “ as shown below.
Cover Shaft Paper
Spring PNE
Lever PNE
Slider PNE
Shaft Paper
BHT (#2), M3x6 (NI)
Lever PNE
Slider PNE
Slider PNE
Spring PNE
Cover Shaft Paper
Slider PNE
[When assembling]
[When assembling]
A’
B’
A
B
FLOIL G-311S
[Lubrication]