Citizen CL-S6621 - Removing the SA, Fan; Removing the Ribbon Covers; SA, Fan

Disassembly, Reassembly and Lubrication
CL-S6621 3-18
3-6-4. SA, Fan
(1) Removing the ribbon covers
1. Open the “Cover Top” Block and remove the “Unit, Ribbon”. Refer to “3-6-2 Unit, Ribbon”.
2. On the right, remove the 2 screws (BH, M3x4 (NI)) and detach the “Cover Ribbon Frame
R”.
3. On the left, remove the 2 screws (BH, M3x4 (NI)) and detach the “SA2, Ribbon Unit Fan” to
the left after lifting it to unhook the claws “A” from the chassis.
Note on reassembling:
• When assembling the “Cover Ribbon Frame R”, pass the wires of the front side cable
through the opening “B” (not “C”).
(2) Removing the “SA, Fan”
1. Remove the 4 screws (PHT (#2), M3x6) and 4 washers (Plain, 3x8x0.5), and detach the
“Bracket Ribbon Fan” (2 pcs.).
2. Remove the “SA, Fan” from the “Cover Ribbon Frame L”.
SA, Fan
Cover Ribbon Frame L
Bracket Ribbon Fan
Plain, 3x8x0.5
PHT (#2), M3x6
J106

)
+
  
   
   ! 
  
*
*