Adjustments
CL-S6621 3-58
9. Press any key on the control panel to store the adjusted value.
Proceed to step 10
to perform reflective sensor adjustment.
[When adjustment failed]
When adjustment failed, “Cannot Setup” is displayed.
1) Press any key on the control panel to return to the screen in step 4.
2) Check the mechanical sensor positions, current Media sensor menu setting, label
paper, etc. and try again.
[Reflective sensor sensitivity adjustment, Media: Tag]
10. Press the [PAUSE] key to select the reflective sensor menu.
“Ini Refl Sensor” screen will appear.
11. Press the [FEED] key to enter the reflective sensor menu.
12. Set tag with black marks, but avoid placing the black
mark part on the reflective sensor.
If you use continuous tag, set it to the printer.
Be sure that the normal adjustments for printing are
correctly made.
• Media sensor menu: “Reflect”/”None” (for continuous
paper)
• Sensor positioning:
The bottom sensor should meet the black mark position.
(However, avoid putting the black mark on the sensor.)
[PAUSE] key
Black mark
To Next Page
Loading...
