Citizen CL-S6621 - Page 91

Disassembly, Reassembly and Lubrication
3-13 CL-S6621
1. Remove the “Cover Top” Block. Refer to “3-6-1(1) Removing the “Cover Top” Block“.
2. Remove the 4 screws (BH, M3x4 (NI)) and detach the “Unit, Ribbon” by lifting it upwardly. At
this time, disconnect 1 connector (J102) from the “Unit, Ribbon”.
Notes on reassembling:
• Seat the cable (J102) on the “Plate Ribbon Cable Stay” as shown below.
• When assembling the “Unit, Ribbon”, be sure that it is securely seated on the main body.
The 2 protrusions on the bottom of the “Unit, Ribbon” are naturally inserted in the respective
holes “A” of the main body for positioning the “Unit, Ribbon”.
A
J102
Plate Ribbon Cable Stay
BH, M3x4 (NI)
Unit, Ribbon
J102