Disassembly, Reassembly and Lubrication
CL-S6621 3-20
Notes on reassembling:
• Distinguish the “Gear Ribbon Shaft F” from the “Gear Ribbon Shaft R”, referring to the following
projection.
• On the front side, assemble the “SA, Holder R Shaft”, “Spring Ribbon Shaft”, and “Spring Ribbon
Return” on the “Gear Ribbon Shaft F”.
Apply FLOIL G-311S to both ends of the “Spring Ribbon Shaft”. Refer to the
marks shown in
the left figure below.
• On the rear side, assemble the “SA, Holder R Shaft”, “Spring Ribbon Shaft”, and “Spring Ribbon
Return” on the “Gear Ribbon Shaft R”.
Apply FLOIL G-311S to both ends of the “Spring Ribbon Shaft”. Refer to the
marks shown in
the right figure below.
• Apply FLOIL G-474C to the parts (gears and shafts) shown by the
marks. (Refer to the figure
on the previous page.)
[Front side] [Rear side]
Gear Ribbon Shaft F
Gear Ribbon Shaft R
Projection
SA, Holder R Shaft
Spring Ribbon Return
Spring Ribbon Shaft
Gear Ribbon Shaft F
Spring Ribbon Shaft
Gear Ribbon Shaft R
Spring Ribbon Return
SA, Holder R Shaft
FLOIL G-311S
To Next Page
Loading...
