Citizen CLP-621 Technical Manual

2-3. Operation Panel
CLP-621 & CLP-631 2-46
How to change the value in the Factory Mode menu
For example, the following shows how to logically move the thermal head position 1 mm
(0.04”) to the right. In this case, you should add 8 (dots) to the current value (e.g. +08).
• Variable range: -16 to +32 dots (default +08 dots) (-2 to +4 mm, -0.08 to +0.16 mm”)
• 8 dots correspond to 1 mm. (203 dots correspond to 1”.)
1. Perform steps 1 to 6 on page 2-42 to enter the Factory Mode menu. See (b) “How to
enter
the Factory/Service Mode”.
2. Press the [PAUSE] key until “Mach Hor Pos” submenu is printed.
Note: In the actual printing, the cursor “^” will be printed instead of “
(underline)”.
3. To set the value to 16 (8 plus 8), press the [FEED] key to move the cursor to the next
digit (+08), and then press the [STOP] key once to specify “1”.
Each time you press the key, the value of the current digit with the cursor will scroll (0,
1, 2, 3, 4, ...., 9, 0).
4. Next, press the [FEED] key to move the cursor to the next digit (+18).
The changed value is printed.
5. Press the [STOP] key 8 times to specify “6”.
Each time you press the key, the value will scroll (8, 9, 0, 1, ...., 6).
6. To save the set value, press the [PAUSE] key.
The set value will be printed. Be sure that the new value is “16”, and then press the
[MODE] key to exit the item.
* If the value is not the one you expected, repeat above operation.
Do you want to change “Factory Mode Menu” items?
Y es=(PAUSE) No=(STOP) Exit=(MODE)
Through Sensor Position +000
Save=(PAUSE) Next Digit=(FEED) Change value=(STOP) Exit=(MODE)
:
:
Mach Hor Pos +08
Save=(PAUSE) Next Digit=(FEED) Change value=(STOP) Exit=(MODE)
Mach Hor Pos +18
Save=(PAUSE) Next Digit=(FEED) Change value=(STOP) Exit=(MODE)
Mach Hor Pos +16
Save=(PAUSE) Next Digit=(FEED) Change value=(STOP) Exit=(MODE)
1 mm
[Front]
Head
+

Citizen CLP-621 Specifications

General

USB port	No
RS-232 interface	Yes
Optional connectivity	Ethernet
USB 1.1 ports quantity	1
USB 2.0 ports quantity	0
Connectivity technology	Wired
Flash memory	2 MB
Certification	UL, C-UL, FCC class A, CCC, CE Marking
Internal memory	8 MB
Number of fonts	2
Built-in barcodes	PDF417, UPC-A, UPC-E
Built-in processor	32 Bit RISC
Mean cycles between failures (MCBF)	1000
Power consumption	2400 mA
Power requirements	100 - 240V, 50 / 60Hz
Compatible operating systems	Windows 2000, XP, Vista
Core diameter	25.4 mm
Ribbon length	360 m
Media thickness	0.0635 - 0.254 mm
Maximum label length	812 m
Maximum roll diameter	127 mm
Supported paper width	19.5 - 118 mm

Weight and Dimensions

Depth	114 mm
Width	91 mm
Height	104 mm