Need help?Do you have a question about the Citizen Model CMP-10 and is the answer not in the manual?
Sounds the buzzer.
Shifts printing position to the next horizontal tab.
Prints data and feeds lines based on line feed amount.
Collectively specifies printing mode by setting bits.
Explains the format and components of command descriptions.
Allows changing the Bluetooth discoverability setting.
Allows changing the pairing information saving setting.
Allows changing the printer's memory switch settings.
Allows changing the serial communication baud rate.
Allows changing the auto power off time setting.
Allows changing the print density setting.
Allows changing the maximum IrDA speed.
Option to save current settings to flash memory.
Advises on printing during low battery conditions to prevent power loss.
Provides guidance on printing after paper cutting to avoid compressed printing.
Details serial data transfer, baud rates, and data configuration.
Describes the pin configuration for the serial interface connector.
Explains the RXD, TXD, Vcc, GND, and RTS signals.
Illustrates RS-232C circuits for input and output.
Outlines IrDA interface, data transfer, baud rate, and logic levels.
Lists supported IrDA protocols and layers.
Details print method, dot density, paper specifications, and reliability.
Specifies supported tracks and card thickness for the card reader.
States the expected lifetime of mechanical components like the power switch.
Provides details on battery type, capacity, voltage, and charging.
Covers printable lines, auto power off time, and low battery detection.
Lists average, peak, and stand-by power consumption.
To Next Page
General
