PMU2300III Series Service Manual
- 13 -
4. Removing “SA, SENSOR”
1. Remove two “SCREW, PHT, M2 × 3” and remove “HOLDER, PCB SENSOR” and “SA,
SENSOR”.
2. Draw out “SA, SENSOR” through the hole on the side of “SA, Chassis”.
5. Removing “SA, PF SHAFT”
1. Remove “E-RING, 3.0” from “SA, PF SHAFT”.
2. Remove “BUSHING, CR SHAFT R” from the side of “SA, Chassis” in the direction of the arrow
and pull out “SA, PF SHAFT”.
HOLDER, PCB SENSOR
SCREW, PHT, M2 × 3
SA, SENSOR
When reassembling, align the hole at
“HOLDER, PCB SENSOR” with the boss.
Blue, green, yellow: paper return sensor
Orange, red, brown: presenter sensor
HOLDER, PCB SENSOR
E-RING, 3.0
BUSHING, CR SHAFT R
SA, PF SHAFT
To Next Page
Loading...
