230
Driving
Jumpy_en_Chap06_conduite_ed01-2016
Switching on / Pause
F Turn thumbwheel 1 to the "LIMIT" position:
the speed limiter mode is selected but is
not switched on (Pause).
F
Switch the speed limiter back on by
pressing button 4, if the speed displayed
is suitable (by default, the last speed
programmed).
F
You can temporarily stop the speed limiter
by pressing button 4 again: the display
confirms that it has been stopped (Pause).
You do not have to switch the speed limiter on
in order to set the speed.
Once the function is selected, you can modify
the speed setting by:
-
using buttons 2 and 3, raising or lowering
the speed displayed:
F
by successive short presses, to modify
by + or - 1 mph (km/h),
F by a maintained press, to modify in steps
of + or - 5 mph (km/h).
-
pressing button 5, if your vehicle has speed
memorisation:
F
the six speeds memorised are displayed
in the touch screen,
F
press the button corresponding to the
speed limit chosen.
The value is then displayed in the instrument
panel.
The selection screen closes after a few
moments.
Adjusting the speed limiter
setting
Switching on the speed limiter requires a
programmed speed of at least 20 mph (30
km/h).
The speed limiter is paused by operation of the
control.
The programmed speed can be
exceeded temporarily by pressing
the accelerator firmly beyond the
point of resistance.
To return to the programmed speed,
simply release the accelerator
pedal until the vehicle returns to the
programmed speed limit.
To Next Page
Loading...
