CITROEN Jumpy 2020 - Page 233

231
6
MEM
Driving
Jumpy_en_Chap06_conduite_ed01-2016
On sharp acceleration, as when
descending a steep hill, the speed
limiter will not be able to prevent
the vehicle from exceeding the
programmed speed.
The limiter is temporarily deactivated
and the displayed programmed speed
flashes.
An audible signal accompanies the
flashing of the programmed speed
when exceeding the speed is not due to
an action by the driver.
Flashing of the dashes indicates a fault with the
speed limiter.
Have it checked by a CITROËN dealer or a
qualified workshop.
Operating faultTemporarily exceeding the
programmed speed
Switching off
F Press firmly on the accelerator pedal,
going beyond the point of resistance,
to
exceed the programmed speed limit.
The speed limiter is deactivated temporarily
and the displayed programmed speed flashes.
An audible signal accompanies the flashing
of the programmed speed when exceeding
the speed is not due to an action by the driver
(steep hill...).
As soon as the vehicle's speed returns to the
programmed value, the limiter operates again:
the display of the programmed speed becomes
steady again.
F
Turn thumbwheel 1 to the "0" position.
The display of speed limiter information
disappears.
-
by pressing button 5, if your vehicle has
speed limit recognition:
F the speed to be memorised is displayed
in the instrument panel,
F press button 5 again to save the speed.
The value is then displayed in the instrument
panel.
For more information on Speed
limit recognition, refer to the
corresponding section.
The use of mats not approved by
CITROËN may interfere with the
operation of the speed limiter.
To avoid any risk of jamming of the
pedals:
-
ensure that the mat is secured
correctly,
- do not fit one mat on top of another.