293
8
In the event of a breakdown
Jumpy_en_Chap08_En-cas-de-panne_ed01-2016
If after around 5 to 7 minutes the
pressure is not attained, this indicates
that the tyre is not repairable; contact
a CITROËN dealer or a qualified
workshop for assistance.
F Switch on the compressor by moving
the switch B to position "I" until the tyre
pressure reaches 2.0 bars.
The sealant is injected into the tyre under
pressure; do not disconnect the pipe from
the valve during this operation (risk of
splashing).
F
Remove the kit and screw the cap back on
the white pipe.
Take care to avoid staining your vehicle
with traces of fluid. Keep the kit to hand.
2. Ination
F Turn the selector A to the "Air"
position.
F Uncoil the black pipe H fully.
F
Connect the black pipe to the valve of the
wheel.
F
Drive immediately for approximately
three miles (five kilometres), at
reduced speed (between 15 and 35 mph
(20 and
60 km/h)), to plug the puncture.
F
Stop to check the repair and the tyre
pressure using the kit.
To Next Page
Loading...
