294
In the event of a breakdown
Jumpy_en_Chap08_En-cas-de-panne_ed01-2016
F Connect the compressor's electric plug to
the vehicle's 12 V socket.
F Start the vehicle again and leave the
engine running.
F
Adjust the pressure using the compressor
(to inflate: switch B in position "I"; to
deflate: switch B in position "O" and press
button C), in accordance with the vehicle's
tyre pressure label (located on the left
hand door aperture).
A loss of pressure indicates that the
puncture has not been fully plugged;
contact a CITROËN dealer or qualified
workshop for assistance.
F Remove and stow the kit.
F
Drive at reduced speed (50 mph [80 km/h]
max) limiting the distance travelled to
approximately 120 miles (200 km).
As soon as possible, go to a CITROËN
dealer or a qualified workshop.
You must inform the technician that you
have used this kit. After inspection, the
technician will advise you on whether
the tyre can be repaired or if it must be
replaced.
Removing the cartridge
F Stow the black pipe.
F
Detach the angled base from the white pipe.
F
Support the compressor vertically.
Beware of discharges of fluid.
The expiry date of the fluid is indicated
on the cartridge.
The sealant cartridge is designed for
single use; even if only partly used, it
must be replaced.
After use, do not discard the cartridge
into the environment, take it to an
authorised waste disposal site or a
CITROËN dealer.
Do not forget to obtain a new sealant
cartridge, available from CITROËN
dealers or from a qualified workshop.
F Unscrew the cartridge from the bottom.
To Next Page
Loading...
