295
8
In the event of a breakdown
Jumpy_en_Chap08_En-cas-de-panne_ed01-2016
Checking / adjusting tyre
pressures
You can also use the compressor without
injecting any product, to check and if necessary
adjust your tyre pressures.
F Turn the selector A to the "Air"
position.
F Connect the compressor's electrical
connector to the vehicle's 12 V socket.
F Start the vehicle and let the engine run.
F
Adjust the pressure using the compressor
(to inflate: switch B in position "I"; to
deflate: switch B in position "O" and press
button C), according to the vehicle's tyre
pressure label.
F
Remove the kit then stow it.
Should the pressure of one or more
tyres be adjusted, it is necessary to
reinitialise the under-inflation detection
system.
For more information on Under-
inflation detection, refer to the
corresponding section.
F Uncoil the black pipe H fully.
F
Connect the black pipe to the tyre valve.
To Next Page
Loading...
