299
8
In the event of a breakdown
Jumpy_en_Chap08_En-cas-de-panne_ed01-2016
F If your vehicle has steel wheels, remove
the wheel trim using tool 3.
F If your vehicle has alloy wheels, remove
the cap from each wheel bolt using tool 3.
F If your vehicle has security wheel bolts,
fit the security bolt socket 4 to the
wheelbrace 1 to slacken the security bolt.
F
Slacken (without removing) the other
wheel bolts using just the wheelbrace 1.
F Position the foot of the jack on the ground,
ensuring that it is directly below the
vehicle's jacking point A or B, the one
closest to the wheel to be changed.
Removing a wheel
Parking the vehicle
Immobilise the vehicle where it does not
block traffic: the ground must be level,
stable and not slippery.
Do not use:
-
the jack for any other purpose than
lifting the vehicle,
- a jack other than the one supplied
by the manufacturer.
If your vehicle has a manual gearbox,
engage first gear then switch off the
ignition to block the wheels.
If your vehicle has an automatic
gearbox, place the gear selector at
position P then switch off the ignition to
block the wheels.
If your vehicle has an electronic
gearbox, place the gear selector at
position A then switch off the ignition to
block the wheels.
Apply the parking brake and check that
the warning lamp is on in the instrument
panel.
The occupants must get out of the
vehicle and wait where they are safe.
Never go underneath a vehicle raised
using a jack; use an axle stand.
To Next Page
Loading...
