CITROEN SYNERGIE - Checking and Setting the Valve Timing (Engines: DHX)

CHECKING AND SETTING THE VALVE TIMING
Engines : DHX
TOOLS
- Crankshaft locating peg : 7014-T.J. or 7014-T.R.
- Camshaft and injection pump locating peg : 7004-T.G. Tool kit 7004-T
CHECKS
- Peg the crankshaft.
- Peg the pulleys (1) and (2) at «a» and «b».
SETTING THE VALVE TIMING.
- Peg the crankshaft.
- Peg the pulleys (1) at «a» and (2) at «b».
- Fit the belt in the following order :
Crankshaft pinion, guide roller (3), injection pump pulley (2), camshaft pulley (1), tensioner roller (5), water
pump (4).
- Remove the pegs.
- Free the tensioner roller (5) (nut (6) and screw (7)), retighten the screw (7).
- Rotate the crankshaft by 2 turns. Do not turn backwards.
- Loosen the tensioner roller (5), allow the tensioner to operate.
- Retighten the screw (7) and the nut (6). Tighten to 1.8 m.daN.
- Check the setting.
NOTE : The injection pump is removed without changing the valve timing.
(immobilise the injection pump pulley using the screws (8x125) at «b»).
B1EP080CB1EP09KC
ENGINE
107