163
INJECTION
FITTING BOSCH INJECTORS (continued)
Fitting an injector.
The copper seal (1) and the fire seal washer (2) are to
be replaced each time they are removed.
NOTE : Fitting parts of different makes is PROHIBITED.
WARNING : Ensure that the fire seal washer (2) is
fitted the right way round
The needle lift type injector (4) is located on cylinder
No. 3.
WARNING : Should the needle lift sensor fail, the
injector holder assembly must be replaced.
IMPERATIVE: Do not reset the pressure of the injector
holder (4).
Tighten the injector holder on
the cylinder head to : 4.5 m.daN.
B1HPOYHC B1HPOYJC
Engine : THY
B1HPOYGC
[1] Injector spanner 77510-T
[2] 7008-T Kit 4123-T
(3) Tighten lightly to avoid distortion.
Tighten to: 7 m.daN.
XM
To Next Page
Loading...
