CITROEN SYNERGIE - Setting the Delphi Electronic Injection Pump - XM

155
INJECTION
SETTING THE DELPHI ELECTRONIC INJECTION PUMP
TOOLS
- Flywheel locating peg : 7017-T.J Kit 7004-T
- EPIC injection pump setting rod : 9043-T Kit 4123-T
SETTING THE PUMP
NOTE : This operation is a pre-positioning of the injection pump.
- Peg the flywheel.
- Tilt the pump towards the outer section of the engine.
- Remove the plug (1).
- Introduce the peg 9043-T into the orifice "a".
- Turn the pump towards the inner section of the engine, pushing locating peg 9043-T fully home.
- Tighten the front and rear nuts of the pump to 2 m.daN.
- Remove the tools.
- Refit the plug (1). Tighten to 0.5 m.daN.
NOTE : No adjustment of the pump controls (managed by the ECU).
Engine : P8C
B1HP0BBC
B1HP0NRC
XM