151
XANTIACHECKS : TURBO PRESSURE
INJECTION
Engine : RHY
TOOLS
[1] Pressure gauge for checking boost pressure : 4073-T.A Kit 4073-T
[2] Sleeve for checking boost pressure : 4185-T
Checks.
IMPERATIVE : respect the following checking requirements : Engine at running tem-
perature. Vehicle running at full load.
Preparation.
- Remove the collar (3) and the sleeve.
- Insert the tool [2] between the pipe (1) and the duct (2).
- Position tool [1] in the vehicle.
- Connect the pressure gauge [1] to the tool [2] with its tube "a" long enough for the gauge
to be positioned inside the vehicle.
Procedure.
- Start the engine.
- Engage first gear and start the engine.
- Engage the gears up to third gear.
- Decelerate to 2000 rpm.
- Gradually accelerate.
- Check the pressure : 0.95 ± 0.05 Bar.
- Remove the tools.
C5FP06RC
B1BP20MC
To Next Page
Loading...
