ENGINE
92
CHECKING AND SETTING THE VALVE TIMING
Engine : LFY - RFV 11/97 #
TOOLS
- [1] Belt tension measuring instrument : 4122-T
- [2] Camshaft locating peg : 9041-T.Z
- [3] Crankshaft locating peg : 7014-T.N
Tool kit 7004-T
- [4] Camshaft pulley locking peg : 4200-T.G
- [5] Tensioning tool : 7017-T.W
- [6] Toothed sector for locking the flywheel : 9044-T
CHECKING THE SETTING
- Turn the engine using the crankshaft screw (1).
- Peg the crankshaft using the tool [3].
ESSENTIAL : Check that the crankshaft DAMPERS pulley is in good condition.
If the hub/pulley markings do not line up, the crankshaft pulley must be replaced.
- Peg the camshafts using the tool [2].
(The locating pegs [2] should slide in easily).
- If this is not the case, set the timing.
NOTE : Camshaft hubs (See page 120).
B1EP12GCB1EP12FC
To Next Page
Loading...
