ENGINE
78
XM
AUXILIARY EQUIPMENT DRIVE BELT
Engine : THY
With air conditioning (continued)
REUSED BELT
- Continue in the same way as for a new belt.
NOTE : In certain cases the roller (3) is in its maximum stop position, and it is not possible to remove the tool
[1] 5714-T.Q (Ø 4 mm) .
- Move the roller (4) using a ratchet wrench (9.52 mm) plus extension to release the tool [1].
- Rotate the crankshaft by 5 turns (Direction of rotation) = 1 turn of the belt.
Measure distance X :
- If measurement X is less than 98 mm, the belt is correctly tensioned.
- If measurement X is more than 98 mm, the belt must be replaced.
B1BP054C
To Next Page
Loading...
