ENGINE
80
XM
BALANCE SHAFT BELT
Engine : THY (continued)
Refitting
- Check that the rollers work properly.
- The balance shaft belt.
- Remove the tool [4].
- Fit the tool [5] to the belt.
- Pre-adjust the tension using the tool [6]. (Placed in the square locating hole of the tensioner roller).
Adjust the tension to :
- New belt 70 SEEM units.
- Reused belt 51 SEEM units.
- Tighten the roller to 4.5 m.daN.
Checking the fitting pre-tensioning.
- Remove and refit the tool [5]. ( Make any necessary corrections).
Fit :
- The guide roller (1), tighten to 4.5 m.daN.
- The timing belt (See pages 115 to 117).
- Pre-tension, then tension the timing belt (See pages 115 to 117).
B1BP04RC
To Next Page
Loading...
