Clarion NX501A - Advanced Settings Configuration; Audio Settings; Navigation and Other Settings; Anti-Theft Code Management

49NX501A
English
English
Owner’s Manual
Balance: Choose the desired volume for left and right
speaker.
Fader: Choose the desired volume for front and rear
speaker.
Select EQ:Choosethedesiredmode:BassBoost,
Impact, Excite, Custom and OFF.
Sub Woofer Ctrl: Choose the desired sub woofer gain
from 0 to 14.
Sub Woofer Phase: Choose the sub woofer phase
normal or reverse.
High Pass Filter: Choose the high pass filter
through/55Hz/85Hz/120Hz.
Low Pass Filter: Choose the low pass filter
through/62Hz/95Hz/135Hz.
Amp Cancel: Choose the amplifier audio output on
or off.
Magna Bass EX: Choose the loudness on or off.
Navigation Setup Menu
Thismenuincludes:GPSTime,NaviInterrupt,and
Voice Guidance
GPS Time: Set the system time to be synchronized
with GPS local time or not.
Navi Interrupt:Therearethreechoose:On/Popup/
Off.“On”:ThenavigationscreenwillcovertoAV
screenwhenreachingsomekeypoint.“Popup”:When
small turn info window will pop up in the top of the
AVscreentoindicatethekeypoint.“Off”:Turnoffthis
function.
Voice Guidance: Enable or disable the navigation
voice guidance.
Others Setup Menu
Thismenuinclude:SetPassword;Parentalcontrol,
Audio Language,Subtitle Language,Blinking, TS
Calibrate, and Load Factory.
Set password: Set the password for DVD parental
control.
Parental control: Set the rating of the age. It contains
KidSafe/G/PG/PG-13/PG-R/R/NC-17/Adult.
Audio Language: Set the Language for DVD Audio.
Subtitle Language: Set the Language for DVD subtitle.
Blinking: Choose the blinking ON or OFF.
TS Calibrate: The function of it is to select the Touch
Screen Calibrate YES or NO.
Load Factory: The function is to select to load factory
default or not.
Set the Anti-Theft code
1. If your unit is unlocked, hold the [ ] button
more then 2 seconds, then the Anti-Theft setting
mode will display. Users can change anti-theft code.
Click [Yes], the numerical keypad is displayed. Enter
the new password twice, then anti-theft code is set
and your unit is secured.
NX501A_Usermanual_EN-CAP_0304.indd 49 2011-3-11 16:41:32