Clarion NX501A - Installation and Wiring Guide; Pre-Installation Steps

56 NX501A
English
Owner’s Manual
INSTALLATION / WIRE
CONNECTIONGUIDE
1. Before Starting
1. This set is exclusively for use in cars with a negative ground
12 V power supply.
2. Read these instructions carefully.
3. Be sure to disconnect the battery “-” terminal before starting.
This is to prevent short circuits during installation. (Figure 1)
2. Package Contents
Main unit ................................................... 1
Wiring harness .......................................... 1
GPS antenna ............................................ 1
Clamp for GPS antenna's cable ............... 3
Double face tape for GPS Antenna .......... 1
Remote control unit .................................. 1
Battery (CR2025) ...................................... 1
(Installed in remote control)
Trim ring .................................................. 1
Cleaning cloth........................................... 1
Owner’s manual and
Installation manual.................................... 2
Electro tap ................................................ 2
2DIN trim ring 200mm wide ..................... 1
Flush mount bolts .................................... 8
Hexagon Head Screw .............................. 8
AV cable ................................................... 1
Line out cable ........................................... 1
Line in cable ............................................. 1
Rear Zone out cable ................................. 1
SWI cable ................................................. 1
External Microphone cable....................... 1
CONTENTS
1. Before Starting ..............................................................................................56
2. Package Contents .........................................................................................56
3. General Cautions...........................................................................................57
4. Cautions On Installation ................................................................................57
5. Installing The Main Unit .................................................................................58
6. Cautions On Wiring .......................................................................................60
7. Wire Connections .......................................................................................... 61
Figure 1
Car battery
NX501A_Usermanual_EN-CAP_0304.indd 56 2011-3-11 16:41:33