Clarion NX501A - Accessory Connections and Warnings; Parking Brake Cord Connection; Rear View Camera Safety Warning

63NX501A
English
English
Owner’s Manual
Connecting the parking brake cord
Connect the cord to parking brake lamp ground in the meter panel.
Note:
•ConnectingtheparkingbrakecordtolampgroundallowsyoutowatchiPod/iPhonevideo/DVDvideo/AVinputwhen
the parking brake is engaged.
•Whentheparkingbrakecordisnotconnected,themonitorwillnotshowanyvideosources.
•If“AUDIOONLY”appearsonthescreenjustafterturningontheACCpowerofthecar,releasetheparkingbrake
while confirming safety, and then engage the parking brake again.
Connecting the accessories
•Connectingtotheexternalamplier
The external amplifiers can be connected to the 6 channel RCA output connections. Ensure that the connectors
are not grounded or shorted to prevent damage to the unit.
•ConnectingtoiPod/iPhonedevice
The iPod/iPhone device can be connected to dedicated iPod/iPhone connection on the main unit. For detailed
information, refer to the instruction sheet or manual for the iPod/iPhone cable.
Note:
•ThisunitmaynotsupportallfunctionsofalliPod/iPhonedevices.
•TheiPod/iPhoneconnectionwillchargeyouriPod/iPhoneunlesstheiPod/iPhonebatteryiscompletelydepleted.If
the specified cord of the cellular phone is connected to the phone interrupt cord of the main unit, the audio mute is
activated when cellular phone in use.
•RearViewCameraWarning:
Foryoursafety,thedrivershouldnotviewtheReversingCameraswhiletravellinginaforwarddirection,whichis
prohibited according to Australian Road Laws.
Clarion strongly recommends that when installing a Reverse Camera to this product, the camera’s power source be
derivedfromthevehiclesreversinglampcircuiteitherdirectly(ifsuitable)orviaarelay.ThiswillensurethattheRear
View Camera can only be viewed while the vehicle is travelling in a reverse direction.
Parking brake lamp
cord to battery
Electro-tap
Parking brake
signal cord
Parking brake
signal cord
Stopper
Parking brake
signal cord
Parking brake
Parking brake cord
(Grass-green)
Parking brake cord
(Grass-green)
Howtoattachtheelectro-tap
1. Place the Parking brake cord at the stopper, and
fold it back in the direction of the arrow
2. Pass the Parking brake signal cord through, and
fold it back in the direction of the arrow.
NX501A_Usermanual_EN-CAP_0304.indd 63 2011-3-11 16:41:35