Clarion NX501A - Vehicle Specific Installation and Removal; Toyota and Other Vehicle Installation

59NX501A
English
English
Owner’s Manual
Installing the Main Unit in TOYOTA Vehicle
Install by using parts attached to the vehicle. (Screws marked are attached to the vehicle.)
*2. Some panel openings are too small for the unit
depending on the vehicle type and model. In such
a case, trim the upper and lower sides of the panel
frame by about 0.5 to 1.5 mm so the unit can be
inserted smoothly.
*3. If a hook on the installation bracket interferes with
the unit, bend and flatten it with a nipper or similar
tool.
Vehicles other than NISSAN and TOYOTA
In some cases the center panel may require modification. (Trimming, filing, etc.)
• Removing the Main Unit
When the main unit is to be removed, disassemble it in the reverse of the order in
“INSTALLINGTHEMAINUNIT”.
Typical Mounting Brackets
Example 1 Example 2
Affix the screws to the marks.
Example 3
* 3
8- Hexagonal screws
(M5x8)
Mounting bracket
(1 pair for the left
and right sides)
Center Panel
(*2)
Main Unit
Figure 6
NX501A_Usermanual_EN-CAP_0304.indd 59 2011-3-11 16:41:33